Chem Mantra
HomeCoursesOnline TestsForum
ForumQuestion Bank

Chemistry Question Bank

19,000+ solved questions for JEE Advanced, JEE Mains, NEET & IChO — with answers and expert explanations.

Filters:NEET Chemistry ×Clear all
4,812 questions found — Page 130 of 193
MEDIUMMCQ SINGLENEET ChemistryInorganic ChemistryEnvironmental Chemistry

Which of the following interrelation with our surroundings are included in environmental studies?

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Galvanic cell is a device in which

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

What is the cell reaction occurring in Daniell cell (Galvanic cell)? (a) Cu s ZnSO aq CuSO aq Zn s -> (b) Zn s CuSO aq Cu s ZnSO -> (c) Ni s ZnSO aq NiSO s Zn s -> (d) 2Na s CdSO aq Na SO aq…

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Which cell converts electrical energy into chemical energy?

HARDMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

The reduction potential at 25oC for Fe3+|Fe2+ electrode is +0.718 V. If , the ratio of molar concentrations of Fe2+ to Fe3+ ions in solution is (2.303RT/F = 0.06, log 5 = 0.7)

HARDMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

For the process: Cu2+ + 2e– → Cu; log[Cu2+] vs. Ered graph is shown in the figure, where OA = 0.34 V. The electrode potential of the half-cell of Cu|Cu2+ (0.1 M) will be [2.303 RT/F = 0.06]

HARDMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Which graph correctly correlates Ecell as a function of concentrations for the cell Zn(s) + 2Ag+(aq) Zn2+(aq) + 2Ag(s), E°cell = 1.56 V Y-axis : Ecell, X-axis : log10 (a) (b) (c) (d)

HARDMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

The e.m.f. of a Daniell cell at 298K is When the concentration of ZnSO4 is 1.0 M and that of CuSO4 is 0.01 M, the e.m.f. changed to E2. What is the relationship between E1 and E2?

HARDMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

On the basis of information available from the reaction 4Al + 3O2 →2Al2O3; ∆G = – 965 kJ/mol of O2.The minimum EMF required to carry out electrolysis of Al2O3 is

HARDMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

A 1.0 M with respect to each of the metal halide AX3, BX2 CX3 and DX2 is electrolysed using platinum electrodes. If The correct sequence in which the various metals are deposited at the cathode is

HARDMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Assertion: Zinc can be used while copper cannot be used in the recovery of Ag from the complex [Ag(CN)2]– Reason: Zinc is powerful reducing agent than copper.

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Cr O 14H 6e 2Cr 7H O; -> E 1.33V. At [Cr O ]l 4.5 millimoles, [Cr3+] = 15 millimoles, E is 1.067 V. The pH of the solution is nearly equal to [KCET 2016]

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Standard electrode potential for Sn4+/Sn2+ couple is +0.15 V and that for the Cr3+/Cr couple is –0.74V. These two couples in their standard state are connected to make a cell. The cell potential will be: [AIPMT 2011]

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

For the reduction of silver ions with copper metal, the standard cell potential was found to be +0.46 V at 25ºC. The value of standard Gibbs energy, ∆Gº will be (F = 96500 C mol–1) [CBSE AIPMT 2010]

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

How many coulombs are required to deposit 50 g of aluminium when the electrode reaction is Al 3e Al -> [RPMT 2010]

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

The equivalent conductance of M / 32 solution of a weak monobasic acid is 8.0 mho cm2 eq–1and at infinite dilution is 400 mho cm2 eq–1. The dissociation constant of this acid is [CBSE AIPMT 2010]

HARDMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Two students use same stock solution of ZnSO4 but different solutions of CuSO4. The EMF of one cell is 0.03 V higher than the other. The concentration of CuSO4 in the cell with higher EMF value is 0.5 M. The concentra…

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

The conductivity of 0.20 M KCl solution at 298 K is 0.0248 S cm–1. What will be molar conductivity? [Haryana PMT 2010] (a)124 S cm2 (b)124 S cm–1 (c)124 S ohm–1 cm2 equiv–1 (d)124 S cm2 mol–1

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

When iron is rusted, it is [MP PMT 2010]

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

At 18º C, the conductance of H+ and CH3COO– at infinite dilution are 315 and 35 mho cn2 eq–1 respectively. The equivalent conductivity of CH3 COOH at infinite dilution is…..mho cm2 eq–1 [CBSE AIPMT 2010]

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Assertion (A) On dilution, the equivalent as well as molar conductivity of solution increases. Reason (R) With dilution, the number of current carrying particles per cm3 increases. [AIIMS 2010]

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Which of the following expressions correctly represents the equivalent conductance at infinite dilution of Al2(SO4)3, Given that o Al and o SO are the equivalent conductance at infinite dilution of the respective …

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Standard electrode potential of cell is (EºAg+/Ag = 0.80V)

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

If the salt bridge is removed suddenly from a working cell, the voltage

MEDIUMMCQ SINGLENEET ChemistryPhysical ChemistryElectrochemistry

Which one of the following is not a function of a salt bridge?

← Previous127128129130131132133Next →
Sponsored

Master Chemistry for JEE, NEET & IChO

Access 19,000+ solved questions with expert explanations, chapter-wise tests, and full video lectures.

Explore Courses →Sign In Free

Difficulty

EasyMediumHard

Question Type

MCQMSQINTEGERSUBJECTIVE

Course

IChO (Chemistry Olympiad)JEE Advanced ChemistryJEE Mains ChemistryNEET Chemistry