Chemistry Question Bank

Which one of the following statements is false?

Four solutions of K₂SO₄ with the following concentration 0.1 m, 0.01 m, 0.001 m and 0.0001 m SOLUTIONS are available. The maximum value of van’t Hoff factor, i, corresponds to

If sodium sulphate is considered to be completely dissociated into cations and anions in aqueous solution, the change in freezing point of water ( Tf), when 0.01 mole of sodium sulphate is dissolved in 1 kg of water, …

If is degree of dissociation of Na₂SO₄, the van’t Hoff’s factor, i, used for calculating the molar mass is

At o 25 C, the total pressure of an ideal solution obtained by mixing 3 moles of ‘A’ and 2 moles of ‘B’, is 184 torr. What is the vapour pressure (in torr) of pure ‘B’ at the same temperature? (Vapour pressure of pure…

A solution contains non-volatile solute of molecular mass M2. Which of the following can be used to calculate the molecular mass of solute in terms of osmotic pressure? (Punjab PMET 2007) (a) m M VRT (b) m RT M V (c) …

Calculate the mass of urea (NH₂CONH₂) required in making 0.25 molal aqueous solution using 2.5 L water. (Haryana PMT 2010)

25.3 g of sodium carbonate, Na₂CO₃ is dissolved in enough water to make 250 mL of solution. If sodium carbonate dissociates completely, molar concentration of sodium ion and carbonate ions respectively are (Molar mass…

A solution of sucrose (molar mass = 342g mol -l) has been prepared by dissolving 68.5g of sucrose in 1000g of water. The freezing point of the solution obtained will be (Kf for water = 1.86 K Kg mol-l) (AFMC 2010) (a)…

If the elevation in boiling point of a solution of 10 g of solute (molecular weight = 100) in 100 g of water is b T , the ebulliscopic constant of water is (Manipal 2010)

The empirical formula of a non-electrolyte is CH₂O. A solution containing 3 g of the compound exerts the same osmotic pressure as that of 0.05 M glucose solution. The molecular formula of the compound is (KCET 2011)

The vapour pressure lowering caused by the addition of 100 g of sucrose (molecular mass = 342) to 1000 g of water (if the vapour pressure of water at 250C is 23.8 mm Hg) is (AFMC 2012)

Of the following 0.10 m aqueous solutions, which one will exhibit the largest freezing point depression? (AIPMT 2014)

To observe an elevation in boiling point of 0.050C, the amount of a solute (molecular weight = 100) to be added to 100 g of water (Kb =0.5) is (WB JEE 2014)

Which one is not equal to zero for an ideal solution? (CBSE AIPMT 2015) (a) mix H (b) mix S (c) mix V (d) observed calculated byRaoult 'slaw p p p Ans. (b) Sol. (i) there will be no change in volume on mixing the two …

(iii) mix S for an ideal solution.

For an ideal solution, the correct option is: (2019) (a) mixV at constant T and P (b) mixH at constant T and P (c) mixG at constant T and P (d) mixS at constant T and P Ans. (b) Sol. For ideal solution, mix mix mix mi…

The mixture that forms maximum boiling azeotrope is: (NEET 2019)

A solution of urea (mol. mass 56 g mol–1) boils at 100.18ºC at the atmospheric pressure. If Kf and Kb for water are 1.86 and 0.512 K kg mol–1 respectively, the above solution will freeze at

25 mg of CaCO₃ is dissolved in 5 L of solution. The approximate concentration of solution is

Calculate the molarity of Na₂CO₃ solution if the normality of Na₂CO₃ Solution is 0.2 N.

Calculate the molarity of H₂SO₄ solution if the normality of H₂SO₄ Solution is 0.4 N.

The vapour pressure of solution of 5g of non- electrolyte in 100g of water at a particular temperature is 2985 Nm-2. The vapour pressure of pure water at that temperature is 3000 Nm-2. The molecular weight of the solu…

The latent heat of vaporisation of water is 9700 cal/mole and if the b.p. is 100 °C, the ebullioscopic constant of water is

Ethylene glycol is used as an antifreeze in a cold climate. Mass of ethylene glycol which should be added to 4 kg of water to prevent it from freezing at – 6ºC will be (Kf for water = 1.86 K kg mol–1. and molar mass o…